How to make a Tassel Pendant

How to make a Tassel Pendant

Materials: 26 gauge half hard round wire (207002), 2mm tiny cable chain (101020), bead cap ( 210005), bead (211015-4), 2 pearls, closed bail (219010)

All metal materials are made of 925 sterling silver

Tools: Bent chain nose pliers- 2 pairs, wire cutters, round nose pliers, measuring tool

The tassel pendant is a trendy new style that is so popular because of its variety and potential. The possibilities are endless with this style of pendant. This tutorial displays a basic tassel with a sterling silver bead, 2 freshwater pearls, and a bead cap. Using the skills and techniques found in this blog can be a base drawing board for you to develop your own designs using many different components from gemstone beads, bezel gemstones, charms, connector links and more components. 

Step 1: Cut wire - 2-4 inches - the larger the topper of the tassel or the larger the beads, cut more wire 

Step 2: Grip wire with round nose pliers about 3/4 inch from end, twist pliers creating a kink, about 80-degree angle, readjust pliers so close to the tip of the pliers sits at the kink

Step 3: Wrap wire around nose creating loop

Step 4: Feed closed bail through open end of loop so it sits inside of the loop

Step 5: Grip the loop with bent chain nose pliers, with 2nd set of bent chain nose pliers, grip the tail and begin wrapping around wire base creating 2-3 coils around, cut and secure tail end by squeezing closed.

Step 6: String beads onto wire- starting with silver bead ( it will cover coils if the hole is large enough, however, if it is a smaller bead or has a smaller hole the coil will show), Before the last pearl is strung, add the bead cap so it is curved downward and will cover the top of the last pearl. ( This step will differ due to design choices)

Step 7: Grip wire extending from the last bead about 2-3mm from the bead and twist pliers to create another kink, adjust pliers making this loop slightly larger than the first loop and bring wire around pliers. (This loop will hold the chain - if you plan on using many pieces of chain to dangle from the tassel than make sure the loop is large enough to hold the chain pieces. )

Step 8: Cutting the chain pieces - cut one piece to desired length ( 1.5"), then loop onto the tail of the wire and feed into the loop. Add another piece of chain and hold it up to measure and ensure they are the same length, cut the chain. Repeat until you have the desired amount of chain tassel dangling. The more you use the more thick and dense the dangle will be. You can pre-cut all the pieces and add them, however, because the chain links are so small you want to make sure there are the same amount of links on each piece or it can look messy, unless your design calls for different chain lengths which can add an interesting effect to the tassel.

Step 9: Once all chain pieces are all inside the loop, grip the loop with the bent chain nose pliers, avoiding squeezing hard on chain links as this will reduce their strength. With second set of pliers or fingers if there is enough wire to grab begin wrapping around creating a coil up to the bead, cut excess wire off and secure tail end by squeezing. 

Thank you


Leave your comment
Only registered users can leave comments.